Low-temperature plasma treatment equipment mainly uses plasma to modify the surface of materials, so as to activate the surface of the material and improve the bonding ability of the material. In many industries, low-temperature plasma treatment equipment is used to improve product adhesion.
Low temperature plasma processing equipment
        Plasma surface treatment equipment for surface treatment of activated materials has the following 5 major advantages:
        1. The product quality is more stable, and the effect of unstable adhesion and poor adhesion will not occur; the impact of other processing conditions on the environment and equipment can be directly excluded;
        2. Cost reduction in the processing industry can save more than 40% of the cost; the surface performance after plasma treatment is durable and stable, and can be maintained for a long time;
        3. It can process online operations, reduce costs, improve work efficiency, and increase product yield.
        4. The sprayed plasma stream is neutral and non-charged, and can be used for surface treatment of various polymers, metals, glass, rubber, PCB circuit boards and other materials; it adopts dry treatment, no pollution, no waste water, and meets environmental protection requirements ；

        5. Increase the bonding strength of plastic products, such as PP material can be increased several times after treatment, most plastic products after treatment, the surface energy reaches a factor of 80 or more;

        The following items need to be paid attention to when using low-temperature plasma processing equipment:
        1. When operating the plasma processor, do not open the case to repair the equipment without professional operation. The host ground wire terminal must be reliably connected to the (earth) ground wire;
        2. The high-voltage cable between the nozzle and the host should be routed naturally and cannot be bent at a large angle; pay attention to the protection of the high-voltage cable to prevent the high-voltage cable insulation from being scratched by sharp objects;
        3. The fans and high-voltage transformers in the main engine are used to clean the surface dust every 6 months, and every 3 months when the environment is bad; do not touch the sprayed plasma flame, otherwise it will cause electric shock and burns;
        4. Poor gas source will cause damage to the plasma nozzle; when there is no gas or the gas source flow is insufficient, the equipment will automatically shut down the protection, and the alarm lamp will beep and flash at the same time.