In the fields of automobile manufacturing, mobile phone manufacturing, glass optics, material science, electronic circuits, printed paper, plastic film, packaging technology, medical equipment, textile industry, new energy technology, aerospace, watch jewelry, etc., plasma vacuum plasma cleaning has been very successful. Wide range of applications.

plasma vacuum plasma cleaning machine
        Surface cleaning activation: improve the surface polarity of the material, perform surface treatment on the material, improve the adhesion effect, and improve the hydrophilic performance. It can be seen from the chart below that the original highly hydrophobic products have greatly improved hydrophilicity after plasma treatment.
        Plasma grafting: When the radicals generated by plasma surface activation or the plasma-induced polymerization layer cannot be firmly bonded to the surface of the material, plasma grafting is usually used for improvement. The basic principle of plasma grafting is: use surface activation to generate new active groups on the surface of the material, and use this group to form chemical covalent bonds with subsequent actives, so that the subsequent actives have specific groups and make them It can not only meet the surface characteristics, but also firmly bond.
        Etching: Plasma cleaning is essentially 5-10 nanometers of plasma etching.
        Some typical applications of plasma vacuum plasma cleaning machine are listed below:
        Mobile phone cover: The cover of mobile phone needs multi-layer coating. Before coating, it is necessary to improve the surface adhesion, clean metal parts with small and harmless treatment, pre-treatment of lens coating, and before joining and sealing of various industrial materials. Processing, etc.
        Plastic printing: Ordinary plastic bottle cap printing. In the production process of the assembly line, if the bottle cap is printed directly, the ink adhesion effect will be poor and the defect rate will be high. The printing packaging and pasting machine will pre-process the edge of the seal. .
        Auto parts: In the production process of the sensor, the surface of the sensor is required to be very clean, which can ensure the accuracy and stability of the sensor, so it must be cleaned, and the car lamp cover, brake pad, door sealant, etc. must be pre-applied.